Image : http://www.flickr.com

If you've been following along with my series, you can deal with the motherboard and all the subtleties of this step should be to find fresh air.

The crankshaft Select the drive and remove from the face of the disk for the installation of the bay. Is not really important, the bay, you are using. I usually put it in front of the case, why is there that is always there for me. If you want to install a Zip drive or CD / DVD bay, simply select theWish. I have both a floppy and CD / DVD, I use both the means to transport data.

Know why people from a floppy disk?

It is called floppy because it flops if you wave. Seriously, do you remember the old 5 ¼ floppy disks, and how, if you turned, they would almost bend.

Now, slide the drive into the bay from the front. If your case is a rack unit, so it may be necessary to remove the rack from the system and then screwseparately from the unit in the rack case. Otherwise, you screw the HDD in the body. Before you do this, make sure that the front of the disc to the front of the PC load.

If you hold the brackets for the drive can do it now. You may need to temporarily disconnect the cables. Once inside, disconnect the drive so far. Check the connections and control connections to other units to ensure that noA bump out of place.

That was not necessarily the most difficult step, but in my humble opinion, this piece of hardware is crucial. Try loading a new operating system or a document required, without either unit.

See Also : Panasonic Blu-ray Player 42 inch LCD TV